• This picture shows the 4 pieces which each adapter bracket is made of.


  • This wooden mock-up shows what the adapter looks like after welding .


  • Here the adapter bracket is mounted on the spindle. Note that I had to grind off some of the surface near the outer perimeter to clear a part of the rotor. If I had been able to obtain thinner material, this would not have been necessary.


  • The rear side of the spindle with the bracket mounted.


  • Here is how the caliper bracket looks mounted on the adapter bracket.


  • A complete assembly. The rotors and calipers are from '69-'72 C bodies. The bearing sizes and distances apart are identical to the drum set-up.


  • Please click HERE for pictures of the setup, installed on the car !